Dust boot mounting sleeve

The new ATE dust boot mounting sleeves are absolutely mandatory for the current ATE caliper generation for safe pressing on of the S-shaped dust boots. The mounting sleeves are equipped with a special profile that is matched exactly to the S-shaped dust boot. The ATE dust boot mounting sleeves are used with the ATE piston retaining appliance (03.9314-4950.3).

Order no.: 03.9314-4910.1 / 760186

• Diameter, outside: 47.4 mm
• Diameter, inside:   42.8 mm
• Height:                 19.6 mm

Order no.: 03.9314-4911.1 / 760187

• Diameter, outside: 52.6 mm
• Diameter, inside:   48.0 mm
• Height:                 19.6 mm

Order no.: 03.9314-4912.1 / 760188

• Diameter, outside: 53.6 mm
• Diameter, inside:   49.0 mm
• Height:                 19.6 mm

Order no.: 03.9314-4913.1 / 760189

• Diameter, outside: 57.6 mm
• Diameter, inside:   53.2 mm
• Height:                 19.6 mm

Order no.: 03.9314-4914.1 / 760190

• Diameter, outside: 61.6 mm
• Diameter, inside:   56.8 mm
• Height:                 19.6 mm

Order no.: 03.9314-4915.1 / 760191

• Diameter, outside: 63.6 mm
• Diameter, inside:   58.9 mm
• Height:                 19.6 mm

Order no.: 03.9314-4916.1 / 760192

• Diameter, outside: 69.6 mm
• Diameter, inside:   64.8 mm
• Height:                 19.6 mm

Order no.: 03.9314-4917.1 / 760193

• Diameter, outside: 72.6 mm
• Diameter, inside:   67.7 mm
• Height:                 19.6 mm

Order no.: 03.9314-4918.1 / 760194

• Diameter, outside: 75.5 mm
• Diameter, inside:   70.8 mm
• Height:                 19.6 mm

Order no.: 03.9314-4919.1 / 760195

• Diameter, outside: 81.6 mm
• Diameter, inside:   76.9 mm
• Height:                 19,6 mm